Olympus OM-1 - Page 109

E-13
2) I mproper positioning of CA8778 (Lever)
Keeping the E pin of 877 5 at the neutral position of it eccentric
motion, bend the Plate (A) so that 8778 will hit the E pin when
the Rear Cover is closed.
3) Improper material used for CA8786 (Ring)
If the material for 8786 is soft and is deformed, replacement will
be required.
4) Improper position of CA8790 (Stopper)
When the Rear Cover is closed, the tip of (8790) should hit the
bottom of the teeth of (8793). If it does not, an adjustment
should be made by bending (8790) at the S position. Some room
may be permissible between (8787) and (8790).
ore/Hard ware http://olympus.dementi