Olympus OM-1 - Page 68

D-2
Then will come off:
CA8753 (Ring) \
CA8749 (Lever) f
CA8751 (Cover) '
CA8750 (Washer)
CA8806 (Screw) I
PSK2 x 2.2SB '
3) R emove CA8777 (Fastener)
in a unit
4) L oosen two NU1.4 x l.SSA on CA9007 (Dial) to remove CA9007.
(CA9007 is screwed in.)
5) O pen CA8705 (Cover) and remove CA8725 (Knob)
Use the tool KC-0071M with care not to deform CA8733 (Shaft).
Then will come off:
CA8726 (Lever)
CA8730 (Pin)
CA8731 (Spring)
6) Remove two PSK1.7 x 4SH on CA8703 (Cover)
CA8703 can be taken off with attachments.
For attachment of CA8703, set the meter at ASA 100, turn off the
meter switch, and mount the CA9005 (Ring) at 100.
7) Remove the following parts.
CA8722 (Spring)
CA9026 a - c (Washer)
NW8.6 - 2136BO
2. Separation of CA8702 (Body front part) from (Die-cast body)
1) Remove two PSK2 x 3SE and two PSK2 x 4SE on CA8704 (Plate).
Then CA8704 and CA6345 (Cover) can be taken off.
2) Remove CA9071 (Stopper) using the tool KC-CA9071G.
Pay attention not to make scratches on CA9134 (Plate).
If scratched, replacement is required.
iwarc