Olympus OM-1 - Page 69

Then will come off:
CA9075 (Spring)
CA9072 (Lever)
3 ) Peel off CA9102 (Leather), CA9103 (Leather).
4 ) Peel off CA8894 (Cover) and CA8893 (Plate), raising the mirror by
CA8917 (Knob). (Glued with Everstic)
5 ) Remove two PSK1.7 x 3SO on CA8734 (Holder) and let CA8734 turn
half way.
6 ) Take off (Lead wires) CA9115 (LW30R), CA9032 (LW45B) by removing
solder.
7 ) Remove CA9036 LW100B from CA9125 (Contact point).
8 ) Remove four PUK2 x 3SO on CA8702 and two PUK2 x 6 SO on CA8961
(Frame) respectively. Then Die-cast body can be separated from
CA8702. _ .
Docking of Die-cast body and CA8702.
Docking is made in the following mannger:
1. Keep the film-advancing mechanism in the state of
being charged.
2. Let the small hole on CA8577 (Gear) face the lens
(at the position of 1 / 1000 ).
3. CA8702 is set at shutter dial 1/1000.
4. CA8702 in the stage of mirror-up.
Setting CA8412 (Charge lever) and raising the mirror by CA8432
(Hook lever), you can proceed with docking. Further, at the
docking, pay attention to deformation of EP Contact point and
Lead-wires as well as the string from the meter. Fasten screws
in accordance with the numbers illustrated below.
hti p://olvm| f)US.(l lemcnti