Olympus OM-1 - Page 71

• D-5
6) Remove HK1.4 - 602SN of CA8836 (Gear).
Then will come off:
CA8836 (Gear) -
CA8851 (Spring)
(Refer to the illustration shown in the next page
how to CA8851)
7) Remove two PSK1.4 x 1.8SO of CA8841 (Base plate) and CA8852
(Screw).
Then will come off:
CA8839 (Gear)
8) Remove CA8856 (Screw)
XCA8828 (Shaft)
B1 (Ball bearing) can be taken off.
Caution: XCA8827 (Shaat)
How to reassemble CA8839 (Gear):
After releasing shutter,
reassemble CA8839 (Gear)
so that the protrudent part
of CA8840 (Plate) may be
inserted between the boss
of CA8547 (Gear) and
CA8842 (Lever). (Insert
A to the arrowed part as
illustrated below)
CA8842
http://olvmpus.demcntia.Org/H