Olympus OM-1 - Page 77

D-ll
8) Pressing CA8811 (Sprocket), remove CA8817 (Screw).
Then will come off:
1 C A8819 (Claw)
CA8818 (Spring)
CA8816 (Gear)
9) Pressing CA8811 (Sprocket), remove CA8788 (Gear)
using the tool KC-CA8788G
10) R emove CA6780 (Holder)
Then will come off:
CA9049 (Spring)
CA9047 (Claw)
CA8779 (Shaft)
CA8811 (Sprocket)
5. Disassembly of CA8702 (Body front part)
1) Remove two PSK2 x 3SO on V40 (Self-timer)
(For the new model, an extra piece is used fixing the self-timer
from the front.)
Then comes off V40.
2) Remove two PUK2 x 4.5SO on CA9025 (Plate).
Then comes off CA9025.
Remove solder from the lead wire at the tube.
3) Pressing CA9130 (Holder) by fingers, remove CA9131 (Holder) and
PUK1.7 x 2.2SO on CA9132 (Holder).
Care must be taken in handling it because of strong tension.
Then will come off :
CA9130
(Holder) "l
CA9131
(Holder)
' . , ; r in a uni
(Holder)
CA9132
CA9133
(Spring)
CA8936
(Cover)
LC4073
(Prism)
CA8904
(Washer)
CA8905
(Mask)
rp://olvmp
us.denicntia.org/Hard’