Olympus OM-1 - Page 81

D-15
12) R emove CA8955 (Screw).
Then will come off:
XCA8925 (Gear)
CA8924 (Pulley)
Positioning of CA8925 and CA8924:
When the groove of CA8924 comes to the position almost
horizontal at the right hand side, the CA8925 should be
in contact with Cam gear stopper
(Removal of CA8410 (Plate) CA8411 (Plate))
13) Remove two PUK1.7 x 1.8SO on CA8889 (Stopper).
Then comes off CA8889.
Positioning of CA8889 may be performed with a jig.
14) Remove XCA8404 (Screw) on CA8410.
15) Remove two PUK2 x 3SO and PUK2 x 2SO which fastens CA8410.
Then will come off:
CA8410 (Plate) and (Relative parts)
CA8401 (Frame)
CA8409 a - c (Washer) a - c
http://olympus.dementia.org/Hardware