Olympus SZX10 - Observation Procedure Summary; Preparation Steps; Basic Observation Steps

6
3 Summary Of Observation Procedure
Ref. Page
1. Check and tighten the connection of each component, especially the observation tube............................................................................(Page
21
)
2. Check that the angled formed by the microscope body with respect to the base is less
than the turning-over prevention angle............................................................................................................................................................................................................................(Page
20
)
3. Adjust the rotation tension of the coarse focus adjustment knob. ...................................................................................................................................................(Page
7
)
4. Confirm the correct settings.
3-2 Observation Procedure
3-1 Preparation
Place a specimen on the stage. (Page 7)
Adjust the interpupillary distance. (Page 10)
1
2
Make diopter adjustment of the eyepieces. (Page 10)
(
The adjustment procedure is variable depending on whether
the eyepiece micrometer disk is used or not.
)
3
Set the zooming knob
a
to the lowest zoom magnification and bring
the microscope into focus by rotating the coarse focus adjustment
knob
b
.
Rotate the zooming knob
a
to the desired magnification and
precisely focus the microscope on the specimen with the coarse
focus adjustment knob
b
and fine focus adjustment knob
c
(the
fine focus adjustment knob is not provided with the SZX2-FO).
The contrast of the observed image and the focal depth of the
specimen can be adjusted with the aperture iris diaphragm
ring.
4
5
TIP
a
b
c
Downloaded from ManualsNet.com search engine