Olympus SZX10 - Revolving Nosepiece SZX2-2 RE10

25
SZX10
2
Assembly
b
Remove the observation tube from the zoom microscope body.
Remove the zoom microscope body and focusing assembly from the
pillar, and place them upside down on a flat desk surface.
Place a soft sheet made of rubber or similar material on
the desk surface.
Remove the objective from the zoom microscope body and then
remove the objective mount
b
by loosening the three clamping
screws
a
using the provided Allen wrench (for M3 screws).
1
2
NOTE
3
9-3 Revolving Nosepiece SZX2-2RE10
The revolving nosepiece allows two objectives to be mounted. This makes objective switching easy by
simply rotating the revolving nosepiece and expands the range of observation magnifications.
TIP
1
External View
Hand guard
Allen wrench
(for M3 screws)
Clamping screws
(M3, 6 mm long, x 3)
Nosepiece mount
Objective mounts
a
Downloaded from ManualsNet.com search engine