Olympus SZX10 - BX Stage Adapter Type 1 SZX-STAD1

28
9-4 BX Stage Adapter Type 1 SZX-STAD1
This adapter is for installation of a U-SRG or U-SRP rotary stage on the SZX2 standard base or a SZX2
series illumination base. When the U-SRP rotary stage is used together with the U-FMP mechanical stage,
X-Y directional movement becomes possible, which is convenient for framing during photomicrography.
To cover the height of the stage adapter (about 44 mm), we recommend combination with the SZH-P400 auxiliary
pillar (together with the SZX-R drop prevention collar).
TIP
1
Mountable Bases, Restrictions
Base Applicable Objectives Restrictions
Standard base
SZX2-ST
0.5X to 2X None
· Quad position LED transmitted
light illumination base
SZX2-ILLTQ
· Single position LED transmitted
light illumination base
SZX2-ILLTS
STAD mount for ILLT SZX2-STADM is necessary for using the stage adapter.
(Refer to the instruction manual for the SZX2-ILLTQ/ILLTS LED transmitted light
illumination base.)
2
Assembly
a
b
a
1
2
c
e
f
d
Use the tools shown in the table below.
Tool Description
Allen wrench (for M4 screw) Provided with SZX-STAD1
Hexagon socket screw (M4) Provided with SZX-STAD1
Place the notch
b
of SZX-STAD1
a
on the back side of the base,
and secure the screws (2 pcs.) using the Allen wrench to attach SZX-
STAD1
a
to a base.
Attach U-SRP or U-SRG2 to SZX-STAD1
a
.
Attaching U-SRP
Place the positioning pin (cylinder type)
c
on the back side of the
base, and rotate the centering knob
d
in clockwise direction to
secure it.
Attaching U-SRG2
Place the protrusion
e
on the front side of the base, and rotate the
clamping screw
f
in clockwise direction to secure U-SRG2 using
the allen screwdriver provided with the microscope frame.
TIP
1
2
Downloaded from ManualsNet.com search engine