1
SZX10
Important
1. After the equipment has been used in an observation of a
specimen that is accompanied with a potential of infection, clean
the parts coming in contact with the specimen to prevent infection.
· Moving this microscope is accompanied with the risk of
dropping the specimen and causing infections. Be sure to
remove the specimen before moving this product.
· In case the specimen is damaged by erroneous operation,
promptly take the infection prevention measures.
· The microscope may become unstable when certain
intermediate attachments and/or photography unit are
mounted on it. Take the measures so that the microscope does
not turn over.
2. To prevent the microscope body from turning over, its left-right pivot
angle must be limited to 30° as shown in figure. The tilt of the
desktop surface should be no more than 5°.
3. Sufficient care is required during observation with a low-
magnification objective, because the objective’s long WD (Working
Distance) can displace the microscope body to a higher position.
The measures for prevention of turning over are also required when
using an auxiliary pillar (SZH-P400/P600), because this also makes
the microscope body to be displaced to a higher position.
4. To adjust the microscope body height, be sure to hold the
microscope body with one hand while loosening the focusing
assembly clamping knob
a
.
(Use the drop prevention collar (SZX-R) to prevent a hazard from
occurring.)
Be careful not to pinch your finger during the adjustment.
Safety Precautions
a
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
