Warnings and Cautions
MOBILE WORKSTATION WM-DP1
6
• Thoroughly review the manuals of all other equipment which will be
used. The manuals contain essential information on using this
equipment safely and effectively.
CAUTION
• Do not exceed the load capacity detailed in Chapter 8.
• Do not lean or stand on any part of the mobile workstation or accessory
as failure of the product may result.
• When assembling equipment onto the mobile workstation, the
installation should meet the requirements of EN IEC 60601-1-1:2001,
the safety standard for medical electrical systems.
• When configuring a system, the user should ensure that there is
sufficient spare equipment available that in the event of a fault in any
part of the system, the endoscopy procedure may be completed or
terminated without endangering the patient.
• Before commissioning an installation including a separation transformer,
ensure its rating will not be exceeded by the equipment connected to it.
• When installing the mobile workstation in the procedure or operating
room, ensure that the mains cable has sufficient slack that it cannot be
pulled taught as the mobile workstation is moved around the working
area. If necessary, relocate the mains connector to a nearer supply
socket.
• Section 6.2 Manoeuvring and Transportation gives detailed instructions
and precautions which must be read and understood before attempting
to move the mobile workstation.
• Spray type medical agents, such as lubricants, anaesthetic or alcohol,
should be used away from the mobile workstation.
Figure 2.1
MAJ-181
(restrictor fitted)
MAJ-1624
or
MAJ-1628
Do not install or operate
LCD monitor arms in this zone
To Next Page
Loading...
