31
This is an example from a previous
attempt at transmitting when the
antenna was disconnected from the
PA .
Reflected power was higher than
350W and a warning message
“Reflected power too high” appeared.
If you touch the yellow “last events”
box on the PA touch screen it will
display the warning details.
In the case of hardware failure or if
your power amplifier is not working
properly, please contact the
manufacturer or your local dealer.
Never try to change or move any part inside the amplifier except the tube or fuses.
Substitution of parts may void intrinsic safety!
Manufacturer’s contacts: OM POWER, s.r.o.
930 30 Báč 126
SLOVAKIA
Email: om-power@om-power.co
6.2. Fuse Replacement
The user is allowed to change mains fuses (6.3 x 32mm), accessible from the rear panel, only. In the
case of fuse (fuses) interruption inside the power amplifier, exchange can be carried out only by
professionally qualified persons! Internal fuses are located mainly on the SWITCH-on board (next
to the HV transformer).
To Next Page
Loading...
