OM POWER OM2501A - Setting up in the Remote Software

41
If necessary it is also possible to change the OM2501A local Port number. Make any changes as
required in the Connection menu. When finished, click OK.
When completely finished, click Apply Settings in the main Menu.
7.4.2 Setting up in the Remote software
In the Remote Control software open the
Manager Settings and enter the IP
Address and Port number that you set in
point 7.5.1.
Press enter, when done. Now you are
ready to work with the OM2501A over
the internet.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.