Why OMCN 3000 Lifting Systems arm lifts but descends?
If the arm of your OMCN Lifting System lifts with the pumping action but then descends to its previous position, the check valve may be dirty or damaged. To resolve this, dismount the valve and clean it with compressed air, handling it with care.
What to do if OMCN 3000 jack does not lift the rated weight?
If your OMCN Lifting Systems jack isn't lifting the rated weight, it could be due to several reasons. The lowering device might be dirty or damaged; in this case, take off the descent device and clean it, replacing it if necessary, and handle with care. Alternatively, the cylinder's gaskets could be worn out, or the overload safety valve might be dirty or damaged, in which case you should send the equipment to the maintenance centre of your authorized dealer.
Why OMCN Lifting Systems arms do not stay in position?
If the arms of your OMCN Lifting Systems do not stay in position, this could be due to yielded cylinder gaskets, in which case you should send the equipment to the maintenance centre of your authorized dealer. Alternatively, the lowering device may be dirty or damaged. To address this, take off the descent device and clean it. If it is still damaged, replace it, handling it with care.
What to do if OMCN 3000 Lifting Systems arm lifts slightly?
If the arm of your OMCN Lifting Systems lifts only slightly with each pumping action, it could be due to a few reasons. The gaskets of the pumping unit may have yielded; if so, remove the pumping unit body that houses the gaskets and replace them. Another possible cause is a lack of oil in the tank. To fix this, add oil to the tank through the plug as indicated in the routine maintenance chapter.
How to fix OMCN 3000 arm if it does not reach maximum height?
If the arm of your OMCN Lifting Systems does not reach the maximum declared height, it may be due to insufficient oil in the tank. To resolve this, add oil to the tank through the plug as instructed in the routine maintenance chapter.
Explains hazard symbols and important information indicators.
Highlights the importance and handling of the manual for safe operation and warranty.
Details the admitted uses for the hydraulic lifting equipment and load capacity.
Lists examples of reasonably foreseeable improper uses and associated dangers.
Specifies required clothing and personal protective equipment for safe operation.
Reports the noise level tests conducted on the equipment.
Explains the placement and importance of various labels on the machine.
Explains the steps for lifting the load using the hydraulic appliance.
Details the procedure for safely lowering the load and retracting the arm.
Provides a detailed breakdown of spare parts with references and diagrams.
Lists all available spare parts with their corresponding order codes.
Details how to record the equipment's identification and first owner data.
Provides forms for recording changes in equipment ownership.
Forms for documenting repairs and replacement of parts.
Table for recording routine maintenance activities and schedules.
Guidance on periodic checks and their registration for safety compliance.
General| Brand | OMCN |
|---|---|
| Model | 3000 |
| Category | Lifting Systems |
| Language | English |
To Next Page
