10
Setpoints/Alarms
10-2
Figure 10-1. Setpoints 1 & 2 Action (Setpoint at 100 with 4% hysteresis)
These two setpoints have selectable single-sided hysteresis. When used as
alarms, the action is immediate (unless a delay is programmed) going into
the alarm zone but turning off is deferred (if latching is not programmed) by
the hysteresis amount.
Figure 10-2. Setpoints 3 & 4 Action
(for Low Alarm with Relay on at -100, relay off at -96 with a hysteresis of 4)
You are now able to program the setpoint features (as described in the
following sections).
To Next Page
Loading...
