Omega DP41-S - Parts of the Meter; Front of the Meter

4.1 FRONT OF THE METER
The following is a brief description of each part of the front of the meter.
Figure 4-1. Front Detail
ITEM DESCRIPTION
1 –.8.8.8.8.8. or 8.8.8.8.8.8.
6-digit, 14 segment, alphanumeric 0.54” high LED display with
programmable decimal point.
2 SETPOINT LED
These LEDs, labeled 1 through 4, display the status of setpoints
1, 2, 3 (Alarm 1), and 4 (Alarm 2).
3 SETPTS BUTTON
This button functions only in the run mode. When the
Setpoint/Alarm features are unlocked, pressing this button
sequentially recalls the previous setpoint settings to the display.
After the ‘MIN’ and ‘MAX’ buttons are used to alter those
values as desired, pressing the ‘SETPTS’ button, again, stores
these new values.
Unless the ‘SETPTS’ button is pressed, each of the four setpoint
values is displayed for approximately 10 seconds after the last
press of the ‘SETPTS’ button. Holding the ‘SETPTS’ button
depressed stalls this automatic sequence, retaining the most
recent setpoint number on the display.
SETPTS
MAX
MIN
MENU RESET
1234
2 2 2
3 4
5
6
7
2
1
4-1
Parts of the Meter
4