Omega DP41-S - Figure 8-10 S3 and S4 Main Board Jumper Positions

8-41
8
Scaling to
Display
Engineering
Units
STRAIN
0
A. Set the correct jumpers on the meter as shown in Figure 8-10.
(Refer to Section 6 for additional information)
Configure jumpers on S1 and S2 as shown in Section 6.
Install jumpers S3A & S3C and S4A & S4C on the main board.
S4A & S4C will provide a factory set 10 Vdc. Adjusting R38 will
vary excitation. Use a multimeter when adjusting R38.
DISPLAY
BD
CBA
S3
SIGNAL INPUT BD
MAIN BD
J9
J2
J1
J3
AC POWER BD
W1
W3
W2
S4
A
T1
BC
R38
J10
(FACTORY CONFIGURED)
Figure 8-10. S3 and S4 Main Board Jumper Positions
Install jumpers on S1 and S2 as shown in Figure 8-11.