9-1
Meter Function Menus
9
EXPLANATION OF LOCKOUT CONFIGURATIONS AND
METER FUNCTION MENUS
HOW TO USE THE TABLES IN SECTION 9
MIN/MAX/MENU These are the buttons on the meter you are to
press to access the parameters given in the
same column.
MAIN MENU/ These are headings for the table columns.
SUBMENU:
DISPLAYED These are parameters seen on the display
INFORMATION: after pressing either ‘MIN’, ‘MAX’, or ‘MENU’
button(s).
NOTE: If you press the ‘RESET’ button two times while the meter is in the
run mode, all Setpoints, Alarms, Peak & Valley will be reset and the meter
will begin new measurements.
If you press the ‘RESET’ button one time while in the configuration mode,
you will move one MAIN MENU backwards and any selection will not be
saved. If you press the ‘RESET’ button two times while in the configuration
mode, you will reset the meter and only those menu items saved by pressing
the ‘MENU’ button will be saved.
9.1 Individual Lockout Information
To restrict access to different parameters of the program in the meter, you
may want to lockout parts of the meter. When you lock out a parameter, it
will no longer appear when you scroll through the menu. To lock out specific
parameters of the meter (setpoint, scaling), refer to the following tables.
Once set (to unlock useful features for a given application and to lock out
any features), these four “L1C”, “L2C”, “L3C”, and “L4C” can be rapidly
skipped over by pressing the ‘MENU’ button four times.
To Next Page
Loading...
