Omega DP41-S - Page 4

8.5 Potentiometer Input, programming the meter
for a desired Display............................................................8-40
SECTION 9 METER FUNCTION MENUS
9.1 Individual Lockout Information...............................................9-1
9.2 Meter Function Menus...........................................................9-7
9.2.1 Input.......................................................................................9-7
9.2.2 RDG.CNF (Reading Configuration) .......................................9-7
9.2.3 RDG SC (Reading Scale) and RDG OF (Reading Offset).....9-9
9.2.4 IN CNF (Input Configuration) ...............................................9-11
9.2.5 IN.SC.OF (Input Scale and Offset) ......................................9-12
9.2.6 DEC PT (Decimal Point)......................................................9-14
9.2.7 CNT BY (Count By) .............................................................9-15
9.2.8 FIL.CNF (Filter Configuration) .............................................9-16
9.2.9 FIL TI (Filter Time Constant) ................................................9-17
9.2.10 SP CNF (Setpoints 1 & 2 Configuration) .............................9-18
9.2.11 AL CNF (Alarm Configuration).............................................9-19
9.2.12 AL FNC (Alarm Function) ....................................................9-21
9.2.13 AL RDG (Alarm Readings) ..................................................9-22
9.2.14 SP DB (Setpoint Deadband)................................................9-23
9.2.15 AL DB (Alarm Deadband) ....................................................9-23
9.2.16 OUT.CNF (Output Configuration).........................................9-24
9.2.17 OT.SC.OF (Output Scale and Offset) ..................................9-25
9.2.18 BAUD (Baud Rate) ..............................................................9-26
9.2.19 SERCNF (Serial Communication Configuration).................9-27
9.2.20 ADDRESS (Multipoint Communications Device Address)...9-28
9.2.21 DAT FT (Data Format) .........................................................9-28
9.2.22 BUS FT (Bus Format)..........................................................9-30
9.2.23 SERCNT (Serial Count).......................................................9-31
9.2.24 Analog Output Calibration Numbers....................................9-32
SECTION 10 SETPOINTS/ALARMS
10.1 Features overview ...............................................................10-1
10.2 Unlocking the Features........................................................10-3
10.3 Selecting “SP CNF” Setpoint Configuration Features..........10-3
10.4 Deviation Function for Alarms..............................................10-4
10.5 Selecting “AL CNF” Alarm Configuration Features ..............10-5
10.6 Selecting “AL FNC” Alarm Configuration Features ..............10-7
10.7 “AL RDG”: Alarm Readings-Select Delay in Alarm Action ...10-8
10.8 “SP DB”: Select “SP 1”and “SP 2” Deadband (Hysteresis) .10-8
10.9 “AL DB”: Select Alarm 1 (“SP 3”)
and Alarm 2 (“SP 4”) Deadband ( Hysteresis) .....................10-8
10.10 “OUT.CNF”: Control Flashing of the Display........................10-9
10.11 Entering Setpoint Levels (in Run Mode)..............................10-9
Table of Contents
ii