8-39
8
Scaling to
Display
Engineering
Units
STRAIN
0
TABLE 8-4
READING SCALE (RDG SC) vs DECIMAL POINT SHIFT
NUMBER OF SPACES
DECIMAL POINT MOVES RDG SC
TO THE LEFT VALUE
0 1.00000
1 0.10000
2 0.01000
3 0.00100
4 0.00010
Go back into the setup mode and enter the new “RDG SC” value,
the 2-point calibration data and move the decimal point.
You must proceed as follows:
MENU SUBMENU 1 SUBMENU 2 DESCRIPTION
L1CNF Skip past
L2CNF Skip past
L3CNF Skip past
L4CNF Skip past
INPUT Skip past
RDG.CNF Skip past
RDG SC 0.00100 Enter new scale value
from above.
RDG OF Skip past (Leave as 000000)
IN CNF INP.6=1 Activates “IN.SC.OF”
(2-point scaling)
IN.SC.OF INPUT 1 20054.3 This is where you
READ 1 00000.0 enter the data
INPUT2 66675.6 obtained during the
READ 2 02000.0 calibration
run (see above)
DEC PT FF.FFFF Correct decimal point
selection
CNT BY Press the ‘RESET’ button
two times to return to the
run mode
To Next Page
Loading...
