Omega DP41-S - Page 9

Figure 15-2b Older RS-485 Option Board and Pin Designations ..........15-1
Figure 16-1 Connector Label Detail.....................................................16-1
Figure 16-2 Connection of External Power for Setpoint Transistors....16-3
Figure 18-1 Meter Housing and Panel Cutout. ....................................18-4
Table 4-1 Rear Connector Descriptions .............................................4-5
Table 8-1 Meter’s Natural Gain Chart.................................................8-5
Table 8-2 Reading Scale (RDG SC) vs. Decimal Point Shift............8-13
Table 8-3 Reading Scale (RDG SC) vs. Decimal Point Shift............8-26
Table 8-4 Reading Scale (RDG SC) vs. Decimal Point Shift............8-39
Table 8-5 Meter’s Natural Gain Chart...............................................8-43
Table 8-6 Reading Scale (RDG SC) vs. Decimal Point Shift............8-52
Table 14-1 Dual Relay Board Jumpers ..............................................14-1
Table 14-2 4 Relay Board Jumpers....................................................14-2
Table 14-3 Pin assignments for the P6, P7 and P18 plugs ................14-3
vii
Figures