7
Safety Instructions
2 Safety Instructions
Before operating the CP CR500, please carefully read the following safety
instructions.
It is not recommended that the CP CR500 be used (or even turned on) without
understanding the information in this manual.
The CP CR500 should only be operated by trained personnel.
2.1 General
Application of high voltage tests is only allowed for operators who are
particularly skilled and experienced in high voltage testing!
The operator is responsible for the safety requirements during the whole test.
Before performing tests using high voltage, please read the following :
– Do not perform any test without having carefully read the CPC 100, CP TD1
and CP CR500 user manuals!
– Read in particular all safety instructions and follow them!
– Do not use the test equipment without a good connection to substation
ground!
– Pay attention to the national and the international standards for the safe
operation of high voltage test equipment (EN 50191, IEEE 510 and others).
– Always follow the five safety rules:
– Never touch any terminal without a visible earth connection!
– Do not open the CP CR500 housing.
FOR YOUR OWN SAFETY
Always follow the 5 safety rules:
1. Insulate
2. Secure to prevent reconnecting
3. Check isolation
4. Earth and short-circuit
5. Cover or shield neighboring live parts
To Next Page
Loading...
Need help?
General
