OmniPod DASH - Set the time zone and time

25
Initial PDM Setup 22 Initial PDM Setup
2. On the number pad, tap each number of your PIN. en tap the checkmark.
3. Enter the same four numbers again to conrm your PIN. Tap the checkmark.
If the second PIN entry does not match the rst, you must repeat the above steps.
Set the time zone and time
To set the current time zone and time:
1. Tap Select One to show the list of time zones.
2. Tap your time zone. You may need to swipe up or down to nd your time
zone.
3. Tap CONTINUE.
4. Tap the 12 hr / 24 hr toggle to choose
your preferred time display. For
example, six hours before midnight is:
• 6:00 PM in 12 hr display
• 18:00 in 24 hr display
5. Place your nger on the Hour scroll
wheel. Slide your nger up or down
to scroll the wheel up or down. Stop
scrolling when the correct hour
appears in the center of the wheel.
6. Scroll the Minute scroll wheel up or
down until the correct minute appears
in the center of the scroll wheel.
7. If using 12 hr time, scroll the right-
most eld and select AM or PM.
8. Review the time and tap CONTINUE.
Caution: Check that you have set the
time correctly. e time setting aects the
operation of several Omnipod DASH™
System features and can impact your
insulin delivery.