The removable keypad is the device used for controlling and programming the Omron 3G3FV.
The control panel has 11 keys and the display has 2 lines. The Control Panel can be attached
directly to the inverter or it can be mounted externally. To change a parameter, enter the group
where the parameter you wish to change is then step up or down to the parameter. Then press the
enter key, and the far left hand unit will flash, by pressing the reset key you can move along the
units to the one you wish to change the value of. Then by using the arrow keys the value can be
adjusted to the new value required, press the enter button again to enter the new value and ‘entry
accepted’ will be displayed.
To enter the programming
section, programming is
selected from the menu and
then you can step through the
groups and enter the one you
want to access.
Enter button
Up arrow
Menu button
The following is the sequence
of events for changing the
access level and then how to
enter the programming mode.
To Next Page
Loading...
