To Next PageTo Next Page
Need help?Do you have a question about the Omron 3G3FV and is the answer not in the manual?
Lists parameters for initial setup like Language, Access Level, and Control Method.
Details parameters related to applications, sequence, and speed control functions.
Sets parameters like Max Frequency, Voltage, Base Frequency, and Base Voltage from motor data.
Sets Motor Rated FLA, Slip, No Load Current, and Term Resistance as per motor data.
Instructions to set motor rated current based on nameplate or measured full load current.
Provides the formula to calculate motor rated slip based on RPM values.
Instructions to set no-load current by measuring and adding 1 Amp to empty car up current.
Illustrates a 4-point S-curve with programmable acceleration and deceleration points.
Lists essential equipment like a tachometer and A.C current meter for commissioning.
Details crucial checks before powering on, including wiring and EMC conformance.
Outlines steps for simulating test runs, checking speed, and adjusting motor phases for direction.
Describes checking high speed, slowing, and levelling in both directions for comfort.
Guides setting acceleration rate, brake lift timing, and brake release adjustments.
Details how to perform a stall test using a clamp meter to measure current.
States that the section lists common fault codes, their descriptions, and causes.
General