Omron 3G3FV - Parameters and Description; Initialization Parameters; Application Programming Parameters

8
SECTION E
Parameters and description
The following table is the list of all the default parameter settings for the Omron inverter. Use
these tables as reference when you are customising macros for your Omron application. The
modified constants section at the end of the manual is a list of all the parameters that have been
changed from this default list for each individual application.
PARAMETERS FACTORY
SETTING UNIT
INITIALISE
A:-
1.00 LANGUAGE
English
1.01 CONSTANT ACCESS LEVEL
Advanced
1.02 INITIALIZE PARAMETERS
1111
1.03 CONTROL METHOD
V/F
1.04 ENTER PASSWORD
0000
1.05 SELECT PASSWORD
No
PROGRAMMING
B:- APPLICATIONS
1.00 SEQUENCE
1.01 REFERENCE SOURCE
Operator
1
1.02 RUN SOURCE
Terminals (D)
1
1.03 STOPPING METHOD
Ramp to Stop (D)
0
1.04 REVERSE OPER
Enabled (D)
0
1.06 CNTL INPUT SCANS
5ms-2scans (D)
1
1.07 LOC/REM RUN SEL
Cycle ext Run (D)
0
2.00 DC BRAKING
2.01 DC INJ START FREQ
0.5
2.02 DC INJ CURRENT
2.03 DC INJ TIME @ START
2.04 DC INJ TIME @ STOP
50%
0.0 (D)
0.5
3.00 SPEED SEARCH
3.01 SPDSRCH AT START
Disabled (D)
0
3.02 SPDSRCH CURRENT
3.03 SPDSRCH DEC TIME
150 (D)
2 (D)
4.00 DELAY TIMERS
4.01 DELAY-ON TIMER
0.0 (D)
4.02 DELAY-OFF TIMER
0.0 (D)
PARAMETERS FACTORY