4.Overview
4
4. Overview
This document describes the procedure for connecting the Inverter (3G3RX-V1 series) of
OMRON Corporation (hereinafter referred to as OMRON) to the NJ-series Machine
Automation Controller (hereinafter referred to as the Controller) via DeviceNet and provides
the procedure for checking their connection.
Specifically, it describes the procedure for connecting DeviceNet using DeviceNet settings of
the project files prepared beforehand (hereinafter referred to as the "procedure for using the
configuration files").
Section 9 A-1 and Section 10 A-2 describe the procedures for setting parameters without the
prepared configuration files (hereinafter referred to as the "procedure for setting parameters
from the beginning").
To follow the "procedure for using the configuration files", prepare the latest "Sysmac Studio
project file" and "CX-Integrator project file" (they are referred to as "configuration files") from
OMRON in advance.
Name
File name
Version
Sysmac Studio project file
(extension: SMC)
OMRON_3G3RX-V1_DN_EV100.SMC
Ver.1.00
CX-Integrator project file
(extension: cin)
OMRON_3G3RX-V1_DN_EV100.cin
Ver.1.00