7．Connection Procedure
7. Connection Procedure
This section describes the procedure for connecting the Controller to Inverter via DeviceNet
using the "procedure for using the configuration files".
This document explains the procedures for setting up the Controller and Inverter from the
factory default setting. For the initialization, refer to Section 8 Initialization Method.
Personal computer
11
Destination
device
Controller
7.1. Overview of Setting up Remote I/O Communications
The following figure shows the relationship of processes to perform DeviceNet remote I/O
communications using the "procedure for using the configuration files".
Opening
project file
Sysmac
S
tudio project file
CX-Integrator project file
Importing
project file
Toolbox
Transferring
scan list
CX-Integrator
Sysmac Studio
Transferring
project data
Precautions
for Correct
Use
Prepare the latest "Sysmac Studio project file" and "CX-Integrator project file" from OMRON
in advance.
(To obtain the file, contact your OMRON representative.)
To Next Page
Loading...
Need help?
General