Omron BN75R User Manual

BN75R/BN150R/BN300R
2
6
Do not disassemble, repair, or modify the unit.
●
Doingsomaycauseanelectricshockorare.
Do not install the unit in other than specied orientations.
●
Dropping or toppling the unit may cause injury.
●
Ifyouinstalltheunitinanorientationotherthanspecied,theunitcannotbeprotectedfroma
battery
uidleakage.
●

Use the included vertical stand when positioning the unit vertically. (Only BN150R and BN300R)
Do not use the unit where the maximum temperature exceeds 40°C.
●
Thebatterybecomesweakrapidly,whichmaycauseare.
●
Doing so may cause a failure or malfunction of the unit.
Do not exceed the ranges specied for environmental conditions during
use/storage.
Do not install or store the unit in the places listed below.
●
Do not store in places where the humidity is lower than 10% or higher than 90%.
●
Do not use the unit in places where the ambient temperature is lower than 0°C or higher than
40°C. (With no condensation)
●
Do not use in places where the humidity is lower than 10% or higher than 90%.
●
Do not install/store the unit in closed places such as cabinets with no clearance, places where
there is flammable or corrosive gas, places with large amounts of dust, places exposed to
direct sunlight, places exposed to shock or vibration, salty or wet places, or outdoors.
●
Installationorstoringtheunitinsuchaplacemaycauseare.
Do not connect equipment that exceeds the output capacity of the unit.
You can use a plug strip to connect additional devices, but do not connect
devices that exceed the current capacity of the plug strip.
●
The current protection of the unit may operate, which may stop the output.
●
Thewiringoftheplugstripheatsup,whichmaycauseare.
Do not pinch or sharply bend the cable.
Do not fold or knot the cable.
Doing so may cause the cable to be damaged or heated, which may cause
an electric shock or a re.
●
If the cable is damaged, stop using the unit and have the cable repaired.
For repair
, contact us; ____
The accessories are designed exclusively for use with this unit.
Do not use any of the included accessories with other devices.
●
Doing so may compromise the safety of devices.
Do not block the air vents (front and rear).
●
Doing so will cause the internal temperature to rise, which may cause the unit to fail and the bat-
tery to deteriorate.
●
Leave at least 5 cm of space between the vent and the wall.
Do not connect a transformer such as a voltage transformer or isolating
transformer to the output side.
●
Overcurrent may damage the UPS or cause it to malfunction.
●
Even when connected to the input side, the UPS may fail or malfunction. Make sure to check the
operation before use.
Do not connect devices that cannot be used with commercial power
supply.
●
When the unit’s power switch is turned ON and an error occurs with the connected device, by-
pass operation is performed and commercial power supply is supplied as is to the connected
devices.
When installing the unit on a rack, place it on the lower shelf.
●
Injury may result if the unit falls.
Caution
(for installation and connection)

Omron BN75R Specifications

General

Brand	Omron
Model	BN75R
Category	UPS
Language	English