Omron BN75R - When Using the Included UPS Monitoring Software to Perform Auto Shutdown

7. Using the UPS monitoring software and contact signal
45
7-1 When using the included UPS monitoring
software to perform auto shutdown
<RS-232C>
1. Connect the UPS to a computer.
Cable: Included connection cable (RS-232C or USB)
* The RS232C and USB cannot be used at the same time.
●
When using PowerAct Pro
"PowerAct Pro" UPS monitoring software
The included "PowerAct Pro" UPS monitoring software allows you to perform shutdown processing
of your PC when a power failure occurs.(It is possible to shut down multiple computers on the
network.)
Also, you can perform desired operation by setting the automatic start/stop of the UPS based on
the schedule setting.
* The time between the occurrence of a power failure and the shutdown of your PC must be
within the backup time measured in "5-1 How to measure backup time" on page 34.
For more information, refer to the Instruction Manual and online help of the UPS monitoring
software.
●
When using Simple Shutdown Software
The included “Simple Shutdown Software” allows you to automatically shut down the PC when a
power failure occurs. For more information, refer to the manual in the CD-ROM.
RS-232C端子
に接 続する
コネクタ
Included connection cable (RS-232C)
Connect to
RS-232C port
Connector
Connect to
RS-232C port
Connector
RS-232C端子
に接 続する
コネクタ
Included connection cable (RS-232C)
Connect to
RS-232C port
Connector
Connect to
RS-232C port
Connector
Included connection cable (RS-232C)
RS-232C端子
に接 続する
コネクタ
Connect to
RS-232C port
Connector
Connect to
RS-232C port
Connector
BN75R
BN150R
BN300R