BN75R/BN150R/BN300R
7
48
7-2
When performing auto-save functions using
the UPS service in Windows Server 2003/XP
+ UPS service driver
When using the included "UPS service driver", the OS standard UPS service in Windows Server 2003/
XP can be used. When there is a power failure the computer can be shut down.
1. Connect the UPS to a computer.
* Only 1 computer can be connected to the UPS
Cable: Included connection cable (RS-232C or USB)
* The RS232C and USB cannot be used at the same time.
For the connection procedure, refer to “7-1 When using the included UPS monitoring software to
perform auto shutdown”.
2. Install the included “UPS service driver” on the computer.
Software to install: UPS service driver
How to install: Refer to the separate “UPS monitoring software installation guide”.
7-3
When performing auto-save functions using
the standard UPS service in Windows Server
2003/XP
When using the product with the optional contact signal card (SC07) and optional connection cable
(BUC26), the OS standard UPS service in Windows Server 2003/XP can be used. When there is a
power failure, the computer can be shut down.
1. Connect the UPS to a computer.
* Only 1 computer can be connected to the UPS
Contact signal card (SC07), sold separately
Connection cable (BUC26), sold separately
For the contact signal card loading procedure, refer to “7-4 Contact signal”.
2. Perform UPS service setup.
You need to make Windows settings in order to perform auto shutdown. There is no need to install
software.
To Next Page
Loading...
