2.Installation and connection
15
2-3
Connecting the equipment
Power supply output group A
Output ON
Time setting
Time setting
Time setting
Time setting
Output OFF
Power supply output group B
Power supply output group C
Caution
Do not connect devices with rated voltage of 100 VAC or higher.
●
The rated output voltage of this device is 100 VAC.
●
Overcurrent may damage the connected devices.
●
Group control of power supply output
The output receptacles of the UPS (BN-R) are separated into 3 groups: A, B, and C.
• The output start times for power supply output group B and C are independent of power supply
output group A, so they can be delayed or set to precede the output stop time.
• The output start/stop time control function is available with the setting on the LCD panel or
when using the “PowerAct Pro” UPS monitoring software (included software) or “SNMP/Web
card” (sold separately).
•
Output ON/OFF can be controlled by operating the LCD panel or with the included “PowerAct Pro”
UPS monitoring software while the UPS is operating.
•
The delay settings and ON/OFF control described here can be performed independently for power
supply output group B and power supply output group C.
This function can be used to set the startup order of servers, peripheral devices, etc.
The output receptacles can also be forcibly turned ON/OFF remotely.
Connecting a device to the power supply output
(1) Disconnect the AC Input Plugs of all devices you want
to back up such as your PC and modems from a wall
outlet (commercial power).
(2) Connect devices you want to back up to the Power Sup-
ply Output Receptacles of the UPS.
• If you need more output receptacles than those of
the UPS, purchase a plug strip and use it for extra
output receptacles.
Wall outlet
(commercial power)
PC
Modem or other
peripheral