Omron BN75R - Page 26

BN75R/BN150R/BN300R
2
14
2-2-2. Stationary installation
Perform installation only as shown in the diagrams below.
●
Horizontal installation
 Attachtheincludedrubberfeetforhorizontalinstallationtothespeciedlocationsonthebottom
of the product.
For stationary horizontal installation, make sure that this product does not slide or fall.
●
Upright installation (Only BN150R and BN300R)
Use the upright stands (2) included with the product. If the upright stands are not used, the UPS
may fall over due to vibration or other reason.
BN150R
BN75R
Assemble the stand. Align the tabs with the slots
and push in until they click.
To disassemble the stand, pull it apart while press-
ing down on the two tabs.
BN150R
tabs