176
Operation Level Section 5-3
This parameter is used to check the manipulated variable for the cooling con-
trol output during operation.
• This parameter cannot be set.
• During heating/cooling control, the manipulated variable on the control
output (cooling) is monitored.
• The default is OFF and the manipulated variable is not displayed.
■ Related Parameters
Standard or heating/cooling (initial setting level): Page 204
MV display (advanced function setting level): Page 227
c-o MV Monitor (Cooling)
The control system must be set to
heating/cooling control.
The MV Display parameter must be
set to ON.
Control Monitor range Unit
Heating/cooling 0.0 to 105.0 %
Function
Monitor
See
See
To Next Page
Loading...
