E5CK-T
E5CK-T
190
J PROGRAM MODE
Pattern number
Synchronized with the pattern
number of level 0 mode.
Step number
Changed to the ramp setting method.
Refer to the
Operation Manual for the ramp setting method.
Time setting method
Target value 0
Step 0 target value
Ramp 0
Step 0 time
Leak time 0
Target value 7
Step 7 target value
Ramp 7
Step 7 time (see note)
Leak time 7 (max.)
Time Setting Method
Set the number of steps to be used beginning with step 0 (e.g., step
0 target value, step 0 time, step 1 target value, and step 1 time).
The step target value can be set within a range between the
lower and upper target value limits. The default value is zero.
The step time can be set within a range between 0.00 and 99.59
(in hr and min or min and s). The default value is 0.00.
Step 0 Step 1 Step 3Step 2
Step 0 time Step 1 time Step 2 time Step 3 time
A: Step 0 and step 3 target values
B: Step 1 and step 2 target values
Time
Step 0 is flat as shown in the above graph. Set step 0 to 0.00 so that
step 1 will be the actual first step when writing ramp-start programs.
Note: Up to step 15 (i.e., a total of 16 steps)
can be set in the time setting method.
To Next Page
Loading...
