3 Communications Data for CompoWay/F
3 - 10
E5@C Digital Temperature Controllers Communications Manual (H175)
*1 After communications parameters have been changed, reset the Digital Controller to enable them.
Note: The alarm function can also be used in Digital Temperature Controllers that do not have any auxiliary
outputs. In this case, confirm alarm occurrences via the status data.
C3 (83) 0010 Communications
Unit No.
*1
H'00000000 to H'00000063 (0 to 99) Commu
nications
setting
C3 (83) 0011 Communications
Baud Rate
*1
H'00000003 (3): 9.6
H'00000004 (4): 19.2
H'00000005 (5): 38.4
H'00000006 (6): 57.6
C3 (83) 0012 Communications
Data Length
*1
H'00000007 (7): 7
H'00000008 (8): 8
C3 (83) 0013 Communications
Stop Bits
*1
H'00000001 (1): 1
H'00000002 (2): 2
C3 (83) 0014 Communications
Parity
*1
H'00000000 (0): None
H'00000001 (1): Even
H'00000002 (2): Odd
Variable
type
Address
Parameter
name
Setting (monitor) value Level
To Next Page
General
