Omron E5EC User Manual

6 - 69
6 Parameters
E5@C Digital Temperature Controllers User’s Manual (H174)
6-8 Advanced Function Setting Level
6
mav
Moving Average Count
• This parameter sets the number of inputs to include in the moving average. The data after
moving average processing is illustrated in the following figure.
• Use a moving average to suppress rapid changes in the input.
pmav
FB Moving Average Count
Position-proportional Models
• You can set the moving average count for the FB input. The data after moving average
processing is illustrated in the following figure.
• Use a moving average to suppress rapid changes in the FB input.
• You can use this parameter only with the E5EC-PR@-8@@ or E5AC-PR@-8@@. (The
Digital Controller must be manufactured in August 2014 or later (version 2.2 or higher).)
Function
Input data
Operation result
Time
Setting
*The default is 8 for models other than the E5@C-@-0@.
Setting range Unit Default
OFF, 2, 4, 8, 16, or 32 Times OFF*
800
Function
Input data
Operation result
Time
Setting
Setting range Unit Default
OFF, 2, 4, 8, 16, or 32 Times 16

Omron E5EC Specifications

General

Mounting Type	Panel Mount
Display Resolution	0.1°C or 1°C
Control Method	ON/OFF
Input Type	Thermocouple, RTD, Analog voltage
Supply Voltage	100 to 240 VAC
Output Type	Relay, Voltage, Current
Size	48 x 96 mm
Control Output	Relay, Voltage, Current
Alarm Output	Relay
Communication	RS-485
Ambient Operating Temperature	-10 to 55°C
Ambient Operating Humidity	25 to 85% RH
Protection Rating	IP20