23
EN
Stopping the Measurement
To stop measurement while measurement is in progress, press [START/STOP] button.
Turning the Power OFF
To shut down the device, hold down at least 3 seconds to [START/STOP] button.
Displaying Last Reading
The previous measurement value (systolic blood pressure, diastolic blood pressure, and pulse rate)
and whether or not an irregular pulse wave was detected can be displayed. In the case of auscultation
measurement, the auscultation icon appears.
Press the [ ] or [ ] button to display the previous data. This function is also available when the
device is switched off.
Note:
When the monitor is left idle for one minute, the backlight will disappear.
Lights while the previous
data are being displayed.
If held down at least 3 seconds when a measurement result is
displayed, the measured data is cleared without being stored.
When the data was measured
in “Auscultation Mode”, the
auscultation icon appears.
If an irregular pulse wave or
body movement was detected,
the irregular pulse wave icon
appears.
2829490-0B_IM-HBP-1320-E-03-04-2020.book Page 23 Thursday, April 1, 2021 8:24 AM
To Next Page
Loading...
