Omron HEM-7380T1-EBK - Data Transmission; Battery Handling and Usage

EN2
t This monitor may not detect a possibility of AFib in people with pacemakers
or debrillators. People with pacemakers or debrillators should therefore
not use this monitor to detect a possibility of AFib.
t DO NOT use this monitor in areas containing high frequency (HF) surgical
equipment, magnetic resonance imaging (MRI) equipment, computerized
tomography (CT) scanners. This may result in incorrect operation of the
monitor and/or cause an inaccurate reading.
t DO NOT use this monitor in oxygen rich environments or near ammable gas.
t Consult with your physician before using this monitor if you have common
arrhythmias such as atrial or ventricular premature beats or atrial brillation;
arterial sclerosis; poor perfusion; diabetes; pregnancy; pre-eclampsia or renal
disease. NOTE that any of these conditions in addition to patient motion,
trembling, or shivering may aect the measurement reading.
t
from infants, toddlers and children.
t This product contains small parts that may cause a choking hazard if
swallowed by infants, toddlers and children.
Data Transmission
t After the pairing process is completed, this product always emits radio
where RF is restricted, such as on an aircraft. Disable the
Bluetooth®
feature in this monitor, or remove the batteries and unplug the
t
damaged. If this monitor or the cable is damaged, turn o the power and
t
multi-outlet plug.
t
t
Battery Handling and Usage
t Keep the batteries out of the reach of infants, toddlers and children.
2.4 Precaution
Indicates a potentially hazardous situation which,
if not avoided, may result in minor or moderate
injury to the user or patient, or cause damage to
the equipment or other property.
t Consult with your physician before using this monitor on an arm where
intravascular access or therapy, or an arterio-venous (A-V) shunt, is present
because of temporary interference to blood ow and could result in injury.
t Consult with your physician before using this monitor if you have had a mastectomy
or lymph node clearance.
t Consult with your physician before using this monitor if you have severe
blood ow problems or blood disorders as cu ination can cause bruising.
t ONLY inate the arm cu when it is applied on your upper arm.
t Remove the arm cu if it does not start deating during a measurement.
t DO NOT use this monitor for any purpose other than measuring blood pressure
and/or detecting a possibility of AFib.
t During measurement, make sure that no mobile device or any other
electrical device that emits electromagnetic elds is within 30 cm of this
monitor. This may result in incorrect operation of the monitor and/or cause
an inaccurate reading.
t DO NOT disassemble or attempt to repair this monitor or other components.
This may cause an inaccurate reading.
t DO NOT use in a location where there is moisture or a risk of water splashing
this monitor. This may damage this moni
tor.
t DO NOT use this monitor in a moving vehicle such as in a car or on an aircraft.
t DO NOT drop or subject this monitor to strong shocks or vibrations.
t DO NOT use this monitor in places with high or low humidity or high or low
t During measurement, observe the arm to ensure that the monitor is not
causing prolonged impairment to blood circulation.
t DO NOT use this monitor with other medical electrical (ME) equipment
simultaneously. This may result in incorrect operation of the devices and/or
cause an inaccurate reading.
t Avoid bathing, drinking alcohol or caeine, smoking, exercising and eating
for at least 30 minutes before taking a measurement.
t Rest for at least 5 minutes before taking a measurement.
t Remove tight-tting or thick clothing from your arm while taking a
measurement.
t Remain still and DO NOT talk while taking a measurement.
t ONLY use the arm cu on persons whose arm circumference is within the
specied range of the cu.
t Ensure that this monitor has acclimated to room temperature before taking
a measurement. Taking a measurement after an extreme temperature
change c
ould lead to an inaccurate reading. It is recommended that you wait
for approximately 2 hours for the monitor to warm up or cool down when
the monitor is used in an environment within the temperature specied
as operating conditions after it is stored either at the maximum or at the
minimum storage temperature. For additional information on operating and
t DO NOT use this monitor after the durable period has ended. Refer to
t DO NOT crease the arm cu or the air tube excessively.
t DO NOT fold or kink the air tube while taking a measurement. This may cause
an injury by interrupting blood ow.
t To unplug the air plug, pull on the plastic air plug at the base of the tube, not
the tube itself.
y
r
esult
ad
mble o
t in i
a
t
t
e
c
o
r
o
e
c
a
et
op
r
a
t
eld
on o
s is w
the m
ian be
f
he
r
p
y
,
y
y
r
f
e
f
f
r
f
o
f
f
r
e u
or an
si
a
r
t
e
th
r
i
o
ther p
r
s moni
v
nou
pe
r
t
or
(
A
V
y
an a
r
) shu