Omron J1000 User Manual (English)

Other manuals for Omron J1000

Questions and Answers:

J
James TurnerJul 29, 2025
What to do if I get a MEMOBUS/Modbus Communication Error on my Omron J1000?
- J
  John LunaJul 29, 2025
  If you encounter a MEMOBUS/Modbus Communication Error with your Omron Inverter, check for faulty or loose wiring, and ensure there are no short circuits. Correct any wiring issues. Additionally, address potential noise interference by using shielded cables, grounding the shield, and installing surge suppressors on equipment like switches or relays. Separate communication wiring from the drive's input power lines and consider installing a noise filter on the input side.
K
Kevin HowardAug 2, 2025
What to do if my Omron J1000 Inverter displays an A/D Conversion Error?
- K
  Kimberly GilesAug 2, 2025
  If you are getting an A/D Conversion Error on your Omron Inverter, first cycle the power to the drive. If the problem persists, the control circuit may be damaged, and the drive may need replacement. Also, check the control circuit terminals for short circuits and correct any wiring errors. Ensure that the control terminal input current does not exceed allowable levels, and reduce the current input to the control circuit terminal (+V) to 20 mA.
J
Jamie MannAug 6, 2025
How to fix motor noise and oscillation in my Omron J1000?
- O
  Oscar HernandezAug 6, 2025
  Loud motor noise in your Omron Inverter can be addressed by increasing the carrier frequency. If you're experiencing motor hunting and oscillation at speeds up to 40 Hz, try lowering the carrier frequency. Note that the default setting for the carrier frequency depends on the drive capacity and the Drive Duty Selection.
M
Mr. Michael PhamAug 11, 2025
How to stop motor hunting and oscillation in Omron Inverter?
- D
  daviskennethAug 11, 2025
  To address motor hunting and oscillation in your Omron Inverter at speeds between 10 and 40 Hz: * If hunting occurs due to insufficient motor torque relative to the load size, reduce the setting. * If hunting and oscillation occur with a light load, increase the setting. * If hunting occurs when using a motor with low inductance, consider lowering the setting.
A
Andrew PowellAug 15, 2025
What causes a Current Offset Fault on an Omron J1000?
- R
  rebeccaconnerAug 15, 2025
  If your Omron Inverter displays a Current Offset Fault, it indicates that the automatically adjusted current offset value exceeded the allowable setting range. The suggested solution is to replace the drive.
S
stacyhuangAug 19, 2025
How do I improve the speed precision of my Omron Inverter?
- M
  Matthew RoseSep 12, 2025
  To improve speed precision on your Omron Inverter, after setting the motor-rated current, motor-rated slip and motor no-load current, adjust the slip compensation gain.
M
Melinda McfarlandAug 23, 2025
How to increase torque at startup for Omron Inverter?
- E
  Elizabeth SweeneyAug 23, 2025
  To address insufficient torque at startup with your Omron Inverter, increase both the minimum and mid output frequency voltages.