Omron JX - Installation; Standard Connections; Terminal Block Specifications

6 Frequency inverters
Standard connections
Terminal Block Specifications
Installation
Terminal Name Function (signal level)
R/L1, S/L2, T/N/L3
Main circuit power supply input Used to connect line power to the drive.
Drives with single-phase 200 V input power use only terminals R/L1 and N (T/L3), terminal
S/L2 is not available for these units
U/T1, V/T2, W/T3
Inverter output Used to connect the motor
PD/+1, P/+
External DC reactor terminal Normally connected by the short-circuit bar. Remove the short-circuit bar between +1 and
P/+2 when a DC reactor is connected.
P/+, N/-
Regenerative braking unit connection
terminal
Connect optional regenerative braking units (If a braking torque is required)
Grounding For grounding (grounding should conform to the local grounding code.)
Inverter
R (L1)
S (L2)
T/N (L3)
PCS
P24
U/T1
V/T2
W/T3
Motor
Note:
To connect the DC reactor,
remove the short-circuit bar.
For Source logic
5
4
4.7 kΩ
3
2
1
L
PD/+1
DC reactor
P/+
N/-
11
24 VDC
CM2
10 kΩ
250 Ω
10 VDC
L
OI
O
H
AM
Frequency
meter
Frequency
setting unit
1 to 2 kΩ
4 to 20 mA DC
Power supply input
Relay output
Common
AL1
AL2
AL0
RY
3-phase 200 VAC
1-phase 200 VAC
3-phase 400 VAC