Chapter 9: High Accuracy Positioning System
Figure 9-10 Removing the E-Stop Button
5.
It requires at least two people to complete this step. Put down a blanket or other pro-
tective surface, and tip the LD-250 on its side (A). Secure the LD-250 so that it cannot
move. Find the speaker assembly (B) toward the front of the LD-250 as shown in Figure
9-11.
Figure 9-11 LD-250 On its Side (A), Showing the Location of Speaker Assembly (B).
6.
Use a 4 mm hex driver to remove the two pairs of M5 screws and washers [(A) and (B)
in Figure 9-12] that retain the loudspeaker assembly to its mount.
Carefully pull out the speaker assembly [(C) in Figure 9-12] until you can reach and dis-
connect both speaker wires.
13732-000 Rev J LDî ±Platform Peripherals Guide 139
To Next Page
Loading...
