Care and Maintenance
MAINTENANCE
To keep your digital blood pressure monitor in the best condition and
protect the unit from damage follow the directions listed below:
• Do not subject your monitor and cuff to extreme temperatures,
humidity, moisture or direct sunlight.
• Do not fold the cuff or tubing tightly.
• Do not inflate the monitor over 299 mmHg.
• Do not disassemble the monitor.
• Do not subject the monitor to strong shocks or vibrations (for example,
dropping the monitor on the floor).
• Do not use volatile liquids to clean the monitor. The monitor should be
cleaned with a soft, dry, cloth.
• Do not wash the arm cuff or immerse it in water.
MAINTENANCE AND STORAGE
25
TO DELETE ALL THE READING
You cannot delete individual stored readings, all the readings will be
deleted.
1. To delete stored measurement results,
while the memory values are
displayed, first press the MEMORY
button. Then while holding it down,
press the ON/OFF button
simultaneously for about 2-3 seconds.
All results will then be deleted.
2. Press the ON/OFF button to turn the monitor off.
If you forget to turn the monitor off, it will automatically shut itself off
after five minutes.
NOTE:
If the date and time are reset to a time before the most recent
measurement, the average value will be based on any measurements
taken after the date and time were reset. However, you can still view the
readings stored in memory.
HOW TO USE THE MEMORY FUNCTION
24
To Next Page
Loading...
Need help?
General
