Be sure to wrap the arm cuff correctly so that you get accurate results.
Measurements can be taken in light clothing. However, please remove
thick clothes, such as sweaters, before taking a reading.
1. Connect the air tube of the arm cuff and the inflation bulb to their
respective air connectors.
2. Put your left arm through the cuff loop.
The air tube should run down the inside of
your forearm and be in line with your
middle finger.
NOTE: If the cuff is not assembled, pass the
end of the cuff furthest from the
tubing through the metal D-ring to
form a loop. The smooth cloth should
be on the inside of the cuff loop.
HOW TO APPLY THE ARM CUFF
15
NOTES:
• Correct posture during measurement is necessary to get accurate
results.
• You should also try to measure your blood pressure at the same time
each day. (Within 1 hour of waking is recommended.)
HOW TO SIT CORRECTLY WHEN TAKING A MEASUREMENT
14
Incorrect Posture
•
Arched back (leaning forwards)
• Sitting cross-legged
• Sitting on a sofa or at a low table
so that you tend to lean forwards
These situations could lead to higher blood pressure reading due to strain or the
arm cuff being lower than the heart.
If the arm cuff is at a lower position than your heart use cushions etc., to adjust
the height of your arm.
To Next Page
Loading...
Need help?
General
