3. Press the MEMORY button again, while
the average reading screen is displayed.
The result from the most recent
measurement is displayed.
The date and time of each measurement is
displayed alternately with the measurement
reading.
4. Press the MEMORY button repeatedly to
cycle through the previous measurement
results.
Keep the button pressed down to cycle
rapidly through the previous results.
5. Press the ON/OFF button to turn off the power.
NOTE: If you forget to turn the monitor off, it will automatically shut
itself off after five minutes.
HOW TO USE THE MEMORY FUNCTION
23
Alternating display
This monitor has a memory capable of storing 21 sets of readings. Every
time you complete the measurement, the monitor automatically stores the
blood pressure and pulse rate. If there are three readings within 10
minutes of the last reading, the average of the three readings is displayed.
NOTE: When 21 sets of readings are stored in memory, the oldest set
will be deleted to store a new set.
1. Press the ON/OFF button to the power
on.
2. When the heartbeat symbol appears on the
display, press the MEMORY button.
If there are three readings stored in
memory that were taken within 10 minutes
of the last reading, an average value for
those reading is displayed. (If there are
only two readings in memory for that
period, the average will be based on two readings. If there is only one
reading in memory for that period, that reading will be displayed as
the average.)
NOTE: If there are no measurements results stored
in memory, the screen to the right is displayed.
HOW TO USE THE MEMORY FUNCTION
22
To Next Page
Loading...
Need help?
General
