D-5
Appendices
MicroHAWK F320-F / F330-F / F420-F / F430-F Smart Camera User Manual
D
Loads a job from slot n or from memory when used with the JOBDOWNLOAD command via FTP.
-r = Start inspections.
Saves current job to slot n.
Returns available memory for device or coprocessor.
Returns maximum memory block for device or coprocessor.
Returns memory fragments for device or coprocessor.
Important: MEMFRAGS is not supported by the HAWK MV-4000. It will return !ERROR.
Returns memory summary “avail/contig/frags” for device or coprocessor. Verbose.
Stops all inspections.
Starts all inspections.
Queries if each inspection on the camera is online. Defaults to all inspections if no inspection is specified.
If the camera is running in a multi-inspection job, this command will return !1 if all inspections are online
and !0 otherwise.
-insp=n specifies the inspection to query if it is online.
Returns photometry settings: Gain, Exposure, and Focus.
JOBLOAD {[-slot=]<n>|-mem} [-r]
JOBSAVE [-slot=]<n>
MEMAVAIL [-cp]
MEMCONTIG [-cp]
MEMFRAGS [-cp]
MEMINFO [-cp] [-v]
OFFLINE
ONLINE
ONLINE? [-insp=n]
QUERYAUTOCAL
To Next Page
Loading...
Need help?
General
