Omron NA Series

13
4-2 Set NA Clock
4-3
Add Devices
4-3-1 Add External Devices
4-1 Import Projects
4-3-2 Add Internal Devices
4-4 Transfer Projects to NA
NA and controllers are
managed in the same project
4-5 Prepare Setting Files
NA and controllers are managed
in separate projects
4-5-1 Prepare Data Log Setting Files
4-5-2 Prepare Restored File
４ Preparation for Demo Screen
Preparation procedure for safety CPU demonstration screens is shown in the flowchart below.
It is necessary to register the safety CPU to monitor in 4-3 “Add Devices.” Make registration of an
external device or an internal device according to your project management.
Additional Information
In the steps of 4-3 “Add Devices,” you can add a controller easily only by setting an IP address if you
don't need to share variables with controllers for demonstration purposes only. Refer to 4-3-1 “Add
External Devices.”