４-３ Add Devices
In this project file, it is necessary to register the safety CPU to be monitored. There are two
methods: adding as an external device and as an internal device. NA can monitor multiple safety
CPU units. The maximum number of registrable units is 16, including controllers to which the safety
CPU is not connected.
4-3-1 Add External Devices
This section describes how to add devices to another project.
If there is no need to communicate between a CPU unit and NA except monitoring a safety PLC,
such as demonstrations, you don't have to set the IP address to add a safety CPU unit. This is a
recommended method.
3. Click [Device] and select
NX-CSG320.
Note: NX102, NX7, and NJ are
also selectable.
To Next Page
Loading...
