2-37
2 Installing the NB Unit and Connecting Peripheral Devices
NB-series Programmable Terminals Setup Manual(V107)
2-5 FINS/UDP Communication Connection
2
2-5-3 Host Types and Settings of Ethernet Unit
Setting Local IP Addresses
Use a Web browser to set the local IP address of the CP-series Ethernet Option Board.
Refer to the following manuals for the setting procedures.
CP1H: SYSMAC CP Series CP1H CPU Unit Operation Manual (Cat. No. W450)
CP1L: SYSMAC CP Series CP1L CPU Unit Operation Manual (Cat. No. W462)
CP1E: SYSMAC CP Series CP1E CPU Unit Software User’s Manual (Cat. No. W480)
Ethernet Connector
CP1W-CIF41
This is the connector used to connect the twisted-pair cable to the Ethernet.
• Electrical Characteristics: Conform to the IEEE 802.3 standard.
• Connector Layout: RJ45 8-pin modular connector (conforms to ISO8877.)
Setting Node Numbers
Set the node number to a unique value from the CX-Programmer or other Support Software. Do not
set it to the same value as any other Ethernet node on the same Ethernet network. Refer to the
following manuals for the setting procedures.
CP1L-EL/EM: SYSMAC CP Series CP1L-EL/EM CPU Unit Operation Manual (Cat. No. W516)
Setting Local IP Addresses
Set the local IP address from the CX-Programmer or other Support Software for the CP1L-EL/EM
series CPU Unit.
Refer to the following manuals for the setting procedures.
CP1L-EL/EM: SYSMAC CP Series CP1L-EL/EM CPU Unit Operation Manual (Cat. No. W516)
Ethernet Connector
CP1L-ETN21
This is the connector used to connect the twisted-pair cable to the Ethernet.
• Electrical Characteristics: Conform to the IEEE 802.3 standard.
• Connector Layout: RJ45 8-pin modular connector (conforms to ISO8877.)
CP1L-EL/EM
WWW.NNC.IR
To Next Page
Loading...
Need help?
General
