What does a device parameter error mean on my Omron Network Router?
If you encounter a device parameter error on your Omron Network Router, it indicates an error occurred in the parameters downloaded from the Network Configurator. Try making the settings again from the Network Configurator. If the issue persists after the settings are corrected, replace the ED Router.
What to do if the baud rate setting changed during operation on my Omron Network Router?
If the baud rate setting was changed during operation on your Omron Network Router, check the baud rate switch setting. If the error persists after the correct setting has been made, replace the ED Router.
What should I do if the IP address setting changed during operation on my Omron Network Router?
If the IP address setting was changed during operation on your Omron Network Router, check the IP address switch setting. If the error persists after the correct setting has been made, replace the ED Router.
What to do if the DeviceNet node address setting changed during operation on my Omron NE1A-EDR01 Network Router?
If the node address switch setting was changed during operation on your Omron Network Router, check the node address switch setting. If the error persists after the correct setting has been made, replace the ED Router.
General| Brand | Omron |
|---|---|
| Model | NE1A-EDR01 |
| Category | Network Router |
| Language | English |
Identifies personnel for whom the manual is intended.
Covers general safety and operational guidelines for product use.
Details critical safety measures for handling, installation, and environment.
Lists certifications and standards the product complies with.
Introduces the ED Router and its primary function for routing FA data.
Identifies and labels the physical parts of the ED Router.
Covers requirements, mounting, and environmental considerations for installing the ED Router.
Provides instructions and guidelines for wiring power supply, DeviceNet, and Ethernet connections.
Details how to set node addresses and baud rates for DeviceNet connectivity.
Explains methods for setting IP addresses and TCP/IP configurations.
Describes how to configure UDP port addresses and displayed addresses on the ED Router.
Explains the meaning and status of the ED Router's LEDs and 7-segment display.
Provides guidance on identifying and resolving hardware, communication, and settings errors.
Details how error history is recorded, saved, and read using the Network Configurator.
Introduces accessing DeviceNet/Safety devices via UDP/IP over an Ethernet network.
Describes the structure of UDP/IP command and response messages.
Illustrates accessing network devices using UDP/IP with sample configurations.
Details configuration settings for Mitsubishi Ethernet Interface Modules used in examples.
Provides sample ladder logic for monitoring safety input terminals via UDP/IP.
Explains how to monitor NE1A-SCPU01-V1 and NE1A-SCPU02 data.
Details how to monitor DST1-series devices like DST1-ID12SL-1, DST1-MD16SL-1, etc.
Lists general operating, environmental, and physical specifications of the ED Router.
Details specifications for DeviceNet network protocol, topology, baud rates, and distances.
Outlines specifications for EtherNet/IP network, including media access and transmission distance.
Provides details on CIP connections, bandwidth, and routing capabilities.
Shows physical dimensions and weight of the ED Router unit.
Lists parameters configurable for the ED Router via the Network Configurator.
Details DeviceNet software settings like baud rate and node address configurable via Network Configurator.
Covers Ethernet/IP settings such as IP address method and DNS usage configurable via Network Configurator.
Describes Ethernet baud rate settings (Auto, 10/100 Mbps, duplex) configurable via Network Configurator.
To Next Page